Van 24 december 15u tot en met 1 januari zijn wij in verlof. 2 januari terug open!

Content: Ø 1 / 1.5 / 2 / 2.5 / 3 / 3.5 / 4 / 4.5 / 5 / 5.5 / 6 / 6.5 / 7 / 7.5 / 8 / 8.5 / 9 / 9.5 / 10 mm

 The THUNDERWEB design is characterized by a conically shaped body that runs thicker at the rear of the drill. The body forms the internal heart of the drill.

Benefits:

• Parabolic cross-section body: generous body thickness which ensures built-in strength, stability and reduces the risk of breakage due to overload to a minimum
• Longer service life: The cutting surfaces of the spiral milling crown perform less work than the spiral drill, which results in more time between the sharpening cycles
• Split point drilling point 135 ° - Extremely accurate start, drill does not start walking
• Polished finish reduces friction and extends drill life
• Impact-resistant ABS housing with reinforced corner
• Accepts higher nutritional power and torque
• Per cutting angle the advantage of faster results and lower milling resistance
• 100% faster: Considerable time savings thanks to the following factors. The spiral milling crown only mills away the circumference of the hole, while the spiral drill has to drill the entire diameter of the hole